Arming the Aircraft

ARMING THE AIRCRAFT

ARMING PRE-CHECK

The EVOLVE 2 makes several internal calibrations and adjustments before each flight. If for any reason, any of the vital sensors or internal equipment has a safety issue, the aircraft will not ARM upon the ARM command given by the operator’s stick and the LEDs under each motor will turn RED. Please refer to the Smart Pilot screen to check for the diagnoses in order to correct the problem.

ARMING

Before arming the aircraft make sure pre-flight checklists are complete and the aircraft is in an area clear of obstacles and loose debris as loose debris can damage the propellers and possibly cause loose debris to act as projectiles doing damage to surrounding property and personnel.

Push both control sticks down and to the right and wait for the LED’s light to change. Move the throttle stick to the middle position and the aircraft is ready to take off manually.

When arming, the LED’s indicators will fast blink different colors followed by a long beep, the motors will then engage, and the propellers will start spinning

• Related Articles

• Disarming the Aircraft

  To understand how to disarm the aircraft, please refer to the diagrams below. DISARMING THE AIRCRAFT After landing the aircraft, hold the throttle stick down and to the left to disarm the motors. The LED indicators will change color followed by a ...

• Aircraft LED Indications

  The aircraft LED indicators are located under each motor and at the rear of the aircraft. The LED indicates the current state of the aircraft. See diagrams below for indications. INITIALIZING / WAITING FOR RC SIGNAL (Front: Red, Rear : Red / Green / ...

• Aircraft Flight Control

  The flight control of the EVOLVE 2 is accomplished by manipulating the control sticks on the Ground Station. Proper orientation must always be considered when flying the aircraft. A basic rule of thumb when remote piloting an aircraft is to realize ...

• Aircraft Battery LED Indications

  When determining the estimated flight time and distance range of any aircraft flight, the user should have an idea of how much flight time is remaining according to the current power percentage left. Below describes the estimated flight times for ...

• Pairing the Ground Station and Aircraft

  The EVOLVE 2 aircraft and its Ground Station should be paired out of the box per factory settings. In the event you need to repair the aircraft and the Ground Station, please follow the steps below: PAIRING PROCEDURES 1. Navigate to the Pairing Page ...