Disarming the Aircraft

Disarming the Aircraft

To understand how to disarm the aircraft, please refer to the diagrams below.

DISARMING THE AIRCRAFT

After landing the aircraft, hold the throttle stick down and to the left to disarm the motors. The LED indicators will change color followed by a long beep and propellers will stop spinning. Make sure all the LED indicators are solidly lit by the same color (either Green or Blue) with no blinking before moving the sticks back to a central position. If the LEDs are blinking the aircraft is still in arming mode, keep the sticks in the same position until all the LEDs are solid (either Green or Blue)



Push both control sticks down and to the right and wait for the LED’s light to change. Move the throttle stick to the middle position and the aircraft is ready to take off manually. 




When disarming, the LEDs will blink rapidly with different colors followed by a long beep, the motors will then engage, and the propellers will start spinning.


    • Related Articles

    • Aircraft LED Indications

      The aircraft LED indicators are located under each motor and at the rear of the aircraft. The LED indicates the current state of the aircraft. See diagrams below for indications. INITIALIZING / WAITING FOR RC SIGNAL (Front: Red, Rear : Red / Green / ...

    • Aircraft Flight Control

      The flight control of the EVOLVE 2 is accomplished by manipulating the control sticks on the Ground Station. Proper orientation must always be considered when flying the aircraft. A basic rule of thumb when remote piloting an aircraft is to realize ...

    • Arming the Aircraft

      ARMING THE AIRCRAFT ARMING PRE-CHECK The EVOLVE 2 makes several internal calibrations and adjustments before each flight. If for any reason, any of the vital sensors or internal equipment has a safety issue, the aircraft will not ARM upon the ARM ...

    • Aircraft Battery LED Indications

      When determining the estimated flight time and distance range of any aircraft flight, the user should have an idea of how much flight time is remaining according to the current power percentage left. Below describes the estimated flight times for ...

    • Pairing the Ground Station and Aircraft

      The EVOLVE 2 aircraft and its Ground Station should be paired out of the box per factory settings. In the event you need to repair the aircraft and the Ground Station, please follow the steps below: PAIRING PROCEDURES 1. Navigate to the Pairing Page ...