Pairing the Ground Station and Aircraft

Pairing the Ground Station and Aircraft

The EVOLVE 2 aircraft and its Ground Station should be paired out of the box per factory settings. In the event you need to repair the aircraft and the Ground Station, please follow the steps below:

PAIRING PROCEDURES
1. Navigate to the Pairing Page under the following path: DRONE SETTINGS > GROUND STATION > PAIRING
2. Turn on the aircraft.
3. Keep the aircraft at least 3 ft away from the Ground Station.
4. Tap “Start Pairing” on the Ground Station screen.
5. Follow the on-screen instructions until the pairing is complete.
Only required if the pilot is trying to pair a new aircraft to the Ground Station or a new Ground Station to the aircraft.

    • Related Articles

    • Linking the Ground Station to an EVOLVE 2 Aircraft

      The EVOLVE 2 aircraft system is pre linked from the factory. If there‘s a situation which requires the Ground Station and the aircraft to be re-linked, or to pair the Ground Station to a new aircraft, please follow the steps below: Navigate to the ...

    • Charging the Ground Station Battery

      CHARGING THE GROUND STATION BATTERY The Ground Station battery can be charged with the supplied battery charger whilst inserted into the Ground Station‘s main housing.  CHARGING THE GROUND STATION BATTERY 1. Connect the charger to a power source.  2. ...

    • Turing On/Off the Ground Station

      When powering on the Ground Station, be sure to provide at least 3 to 6 ft (1 to 2m) of space between the Ground Station and the aircraft. (If the Ground Station and aircraft are too close together the system may not properly connect.) Short press ...

    • Ground Station Button Customization

      The Ground Station has 6 customizable buttons allowing our users to personalize control of the camera and gimbal. You can customize the buttons under the following path: DRONE SETTINGS > GROUND STATION > BUTTON CUSTOMIZATION

    • Ground Station LED Indicator

      The Ground Station LED indicator is located below the bottom screen. The LED indicates the current state of the Ground Station battery. When charging, the Ground Station LED will blink Red, until the battery is fully charged. Once charged, the LED ...